As I stated in a previous blog, I was in search of some side or nerf steps for my 2006 Toyota Tundra. When I found the N-FAB Wheel to Wheel Nerf Steps, my search was over. The look was perfect! The main bar is positioned high, fixed tightly for better aesthetics, and hides the exposed frame (which is usually very visible under the truck). The N-FAB stainless nerf steps will work on trucks with or without a body lift, so no modifications were needed. The main bar extends from wheel well opening to wheel well opening, giving the step bars a more complete and finished look.

I read through the instructions and was able to get to work quickly. The total process took less than an hour. All of the hardware you need is either included or already on the truck (reused bolts). With my suspension lift already on the truck, it was the perfect height for this installation – not too high or low. There were two bolts that needed to be removed from underneath the cab of the truck so the mounting tabs could sit properly with the body. Also, I thought it might be a good idea to use some type of thread locker on the bolts, just to be on the safe side. With help from my dad, who helped me hold the bars level as I installed the bolts, one side was complete in no time at all. In a few more minutes, the process was repeated on the other side of the truck. From start to finish (including clean up), the entire process took less than an hour.
These bars changed the look of the truck completely. I could not be happier with the addition and the wife likes them as well (which is a big plus!). They look great, are not too low or high, and give the truck a more aggressive look. Check out 4 Wheel Parts for the full line of N-FAB products:

tundra-nerf-steps